 |
 DJ Laser Party Light PROJECTOR+MP3 Player+Speakers+2G $99.99 Time Remaining: 11d 3h 58m Buy It Now for only: $99.99 |
Projector Light
Aiming the Projectors
Projector headlight will increase the visibility and also last longer than the standard headlight bulbs. A bright light produced by the projector headlights will create the dangerous situation when it is improperly adjusted. When the projector headlight will be aimed high, it may blind the oncoming traffic. If the projector light will point too low, the nighttime visibility may be impaired.
Both of the situations will be avoidable when you are adjusting the projector headlights in order to aim properly. Correctly adjusted the headlights will aim the lower than the eyes of the driver and also slightly past a passenger side of the vehicle. Here is more information for you.
For the first step, you should place the vehicle on the level surface with the lights on and also sitting five feet from the smooth vertical surface. After that, mark a center of every light on a vertical surface with the four inch long piece from masking tape. Then, place the length of masking tape that across the top of the edge of the light emitted from your projector headlights.
For the second step, you can move the vehicle 25 to 30 feet from a masking tape marked the vertical surface. Measure the distance from a top of a masking tape to the top line of a projector light with the tape measure. Remember that the light must rest about two to four inches that is below a masking tape.
For the next step, open a hood of the vehicle. After that, turn a top adjustment screw of the side light clockwise of the driver in order to raise or even counterclockwise in lowering the projector light with the regular screwdriver or even the socket attached to the 3/8-inch ratchet handle, it will depend on the vehicle. Remember to stop adjusting when a top edge of a light will rest at least the two inches below a masking tape.
For the last step, adjust a passenger side light in order to match the height of the side light of the driver. After the, turn a horizontal screw in order to set a projector light the two inches to the right of a vertical masking tape line that is designating a center of the side light of the driver at the five feet. Then, close a vehicle hood once the adjustments will be complete.
About the Author
LCD projector lamp will work best for your LCD projector. This is one your need when your entire projector lamp is getting old. As consideration, you can choose BenQ projector lamps that will be great in handling your needs.
what is the cost of pulsar 220 projector head light? only the projector light not the whole light system?
depends where you buy it, but about $25
SPECDTUNING Installation Video: 1999-2004 Mustang Projector headlight installation video